Advertisement
Step 7
1
Attach weather stripping 3/16x2 (5
mm x 5,1 cm) to one end, on the
inside of rear roof channels. Con-
tinue to stick weather stripping to rear
roof channels. Peel paper backing.
2
Fasten top of right roof panel
using two #10-32x7/16" (11 mm) bolts
and square nuts into bottom flange,
on rear roof channel. Fasten bottom
of panel using two #10-32x3/4" (19
mm) bolts into front facia. Pass bolt
through panel and tighten until snug.
Do not over-tighten.
IMPORTANT
2x4's (38 mm x 89 mm) centered
under roof panel will help you
align the holes
3
Lock a main roof panel and right
roof panel together and slide into the
rear roof channel. We recommend
that the two mating edges are lubri-
cated with a liquid detergent when
sliding into the channel. Use a 2x4
(38 mm x 89 mm) and hammer to
lightly tap roof panels into place. Be
sure entire rib on roof panels are
interlocked together.
4
Fasten top and bottom of panel in
the same manner. Fasten overlap-
ping ribs to rear roof channel using a
#10Ax3/8" (10 mm) screw.
5
Continue installing the remaining
seven main and the left roof panel
as before.
NOTE
Leave out outer rib screw for trim
piece in the next assembly step
on the right and left roof panel
● Parts Needed For ●
Roof Assembly
To square unit, measure diagonally. Make
sure both diagonal measurements are the
same. These measurements are taken from
opposite ends of facia and rear wall channel.
Measure from the top outside edge of facia to
the top outside edge of the rear wall channel.
If diagonal dimensions are not the same,
adjust assembled facia section left to right
until the diagonals are equal.
Rear Roof Channel Assemblies
Concrete Slab
● ● ● ● ● 9662 Right Roof Panel (one)
● ● ● ● ● 9653 Main Roof Panel (eight)
● ● ● ● ● 9663 Left Roof Panel (one)
● ● ● ● ● 66626 Weather Seal
3/16x 2 (5 mm x 5,1 cm) (one)
Diagonal Measurement
Rear Roof Channel Assemblies
3/16 x 2 (5 mm x 5,1 cm)
Weather Seal
Level
STEP
1
Advertisement
