Advertisement
Step 6
1
Fasten front splice trim to the
seam where front facia meets with
four #10 screws.
2
If a special mounting board was
used, use remaining front splice trim
pieces to cover ends of board, in-
stead of corner trim. Fasten using
two #10 screws.
3
Position corner trim to inside
corners with short flange to facia and
fasten with two #10Ax3/8" (10 mm)
screws. Position corner trim to out-
side corners with long flange on the
front facia, and fasten with four #10
screws.
Repeat procedure on opposite end
of unit.
9669
9670
STEP
2
● Parts Needed For ●
Corner/Front Splice
Mounting Board
Short Flange
9670
Trim
Long Flange
● ● ● ● ● 9670 Corner Trim (four)
● ● ● ● ● 9669 Front Splice Trim (three)
9670
9669
STEP
1
STEP
3
9670
Advertisement
