Zte ZXV10 ET501 Product Description page 10

ZXV10 ET501 Product Description
l The router software must support the QoS protocol and algorithm. Otherwise, you
should upgrade the router software.
l
Configure QoS for video and ordinary services on routers to ensure that video packets
are not discarded in case of network congestion.
l
Configure Work Mode of the connected device in accordance with the following
requirements:
When you connect a terminal, set the network interface to Auto, and set the
à
network device on the peer end to Auto as well. In some cases, both ends can
be (but not recommended to) set to 100 M/Full-duplex. Never set one end to
Auto and set the other end to 100 M/Full-duplex.
Because the network interface of the MCU ZXV10 M9xxx is set to Auto and it
à
cannot be modified, the network interface connected to the ZXV10 M9xxx can be
set only to Auto.
If the terminal, MCU, and network device are set to different work modes, network
packets may be lost in one direction, and the video services are affected.
The supplementary recommendations are as follows:
l The number of route hops should be as few as possible. The number of route
hops should be reduced, because too many transmission hops may affect the video
transmission. The video device should be connected to the master switching device.
l
Different VLANs should be used to isolate video conference services and other
services.
l
In case of network congestion, the buffer sequence should be used first. The larger the
buffer, the better, and the buffer should be allocated independently for each interface.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
reasonable protection against harmful interference when the equipment is operated in
a commercial environment.
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
SJ-20161028111501-001|2017-04-10 (R1.0)
Notice!
This equipment generates, uses, and can radiate radio
1-4
These limits are designed to provide
ZTE Proprietary and Confidential