Chapter 2. Macintosh Configuration; Installing The Digi 001 Hardware - DigiDesign DIGI 1 Quick Start Manual

chapter 2
Macintosh Configuration

Installing the Digi 001 Hardware

Before installing the Pro Tools LE software, first install the Digi 001 card.
To install the Digi 001 card in your Macintosh:
Turn off your computer. Leave it plugged in so that it is grounded.
1
Open the computer case. If necessary, refer to the manufacturer's instructions for details.
2
Remove the rear slot cover and screw of any available PCI expansion slot.
3
PCI card installation for Macintosh Blue & White G3
Before handling the Digi 001 card, discharge any static electricity by touching the outer
4
casing of the power supply.
Remove the Digi 001 card from its anti-static bag.
5
Hold the card gently by the top edges, and line up its PCI connector with the PCI slot
6
inside the computer.
Chapter 2: Macintosh Configuration 5