Table of Contents
Advertisement
When the number displayed is in the correct format for dialing, following the above step to dial the
number.
3.3.16
Volume control
To adjust the listening volume on a handset: Press DIR / CID to adjust the listening volume when
on a call. Each press of the button increases or decreases the volume level by one increment.
NOTES
1. All volume settings (handset and speakerphone) are independent.
2. When the volume reaches the minimum or maximum setting, you will hear two beeps.
3.3.17
Multiple handset use
You can conference with another system handset while you are on a HOME or CELLULAR call.
However, you cannot conference between a HOME call and a CELLULAR call. A maximum of
two handsets can be used on an outside call. If a handset is already on a HOME call and you
would like to join the call, press HOME/FLASH or SPEAKER on another system handset.
OR
If a handset is already on a CELLULAR call and you would like to join the call, press CELLULAR
on another system handset.
Press OFF/BACK or place the handset in the telephone base or charger to end the call. The call
will not be terminated until all handsets hang up.
NOTE
A maximum of
four
handsets can be used at a time. When two handsets are being used on either
the HOME or CELLULAR call, the other two system handsets can be used for a call on the line
that is not being used.
3.3.18 Mute
The mute function allows you to turn off the microphone. You can hear the caller, but the caller
will not be able to hear you.
To mute a call:
• Press DELETE/MUTE to turn off the microphone. When mute is on, the handset screen will
show MUTED for a few seconds and the MUTE icon will be shown until mute is turned off.
To un-mute a call:
• Press DELETE/MUTE again and resume speaking. When mute is turned off, MICROPHONE
ON will display temporarily on the handset screen.
3.3.19 Hold
You can place a HOME or CELLULAR call on hold. You will hear an alert tone if you have not
taken the call off of hold after 14 minutes. You will hear another alert tone 30 seconds later. At 15
minutes on hold, the call will automatically disconnect.
To place a HOME call on hold:
• Press the HOLD key on the handset. HOME LINE HELD will appear on the display and
HOME/FLASH LED will flash.
To resume a HOME call that is on hold:
• Press HOME/FLASH again.
To place a CELLULAR call on hold:
• Press the HOLD key on the handset. CELL LINE HELD will appear on the display and
CELLULAR LED will flash.
Advertisement
Table of Contents
