Cobalt Digital Inc 9902-2UDX Product Manual page 20

1
OGCP-9000 Control Panel
or
OGCP-9000/CC Control Panel
9902-2UDX Card
Computer
with NIC
Note: • To communicate with DashBoard™ or a Remote Control Panel, the frame must have a Network Controller Card installed
in the frame.
• DashBoard™ and the Remote Control Panels provide network control of the 9902-2UDX as shown. The value displayed
at any time on the card, or via DashBoard™ or a Control Panel is the actual value as set on the card, with the current value
displayed being the actual value as effected by the card. Parameter changes made by any of these means are universally
accepted by the card (for example, a change made using the DashBoard™ controls will change the setting displayed on
a Control Panel).
1-16
Remote Control Panel
Using the Control Panel,
9902-2UDX card can be remotely
controlled over a LAN
20-Slot Frame with Network Controller Card
DashBoard™ Remote Control
Using a computer with
DashBoard™ installed,
9902-2UDX card can be
remotely controlled over a LAN
Figure 1-5 9902-2UDX User Control Interface
Note: If network remote control is to be used for the frame and the frame has not yet
been set up for remote control, Cobalt
User Guide (PN 9000RCS-RM) provides thorough information and
step-by-step instructions for setting up network remote control of Cobalt
cards using DashBoard™. (Cobalt
Remote Control Panel product manuals have complete instructions for setting
up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the Support>Reference
Documents link at www.cobaltdigital.com and then select DashBoard
Remote Control Setup Guide as a download, or contact Cobalt
Contact Cobalt Digital Inc. (p. 1-21).
9902-2UDX PRODUCT MANUAL
9902-2UDX Functional Description
In conjunction with a frame equipped
with a Network Controller Card,
9902-2UDX card can be remotely
controlled over a LAN
®
reference guide Remote Control
®
OGCP-9000 and OGCP-9000/CC
LAN
®
®
as listed in
9902-2UDX-OM (V1.0)