Cobalt Digital Inc 9902-2UDX Product Manual page 118

3
.
Electronic device or assembly is susceptible
to damage from an ESD event. Handle only
using appropriate ESD prevention practices.
From underside of card, locate
1
the SD card receptacle
With SD card labeling facing up
2
(as shown), gently push the
card into the receptacle until it
clicks and locks into place
3-80
(See Figure 3-10.) Make certain the card has the proper SD card installed
1.
in the under-card slot. If SD card is not installed, contact Product Support
to obtain an SD card.
Note: • (Option +TTS only) Cards shipped with option +TTS use an SD card for the
TTS library in addition to recovery files. If your +TTS-equipped device was
received earlier than December 2015, your SD may not contain the recov-
ery files. Contact Product Support to obtain the updated SD card containing
both TTS library and SD recovery files.
• If unit is a BBG-1000 Series device, remove the top cover before
proceeding.
Figure 3-10 SD Card Installation
(See Figure 3-11.) With card powered-down, locate the
2.
button on the card. Proceed as shown in picture.
9902-2UDX PRODUCT MANUAL
Troubleshooting
MMC BOOT
9902-2UDX-OM (V1.0)