Cobalt Digital Inc 9902-2UDX Product Manual page 103

Operating Instructions
Table 3-2 9902-2UDX Function Menu List — continued
in the example here, Event Timer 1 is used to set a logo insertion disable after a specific amount of elapsed time. A GPI inserts
the logo, along with a time started at that time. Upon the timer timeout, a separate action sets logo insertion to Disabled.
As an Event Action choice on the Events Triggers sub-tab, an Email alert can be sent as a response. Set up email fields as
shown in the example below.
Note: Frame hosting the card must be accessible to email recipient's network. It is recommended to set up and generate a test
event to test the email send.
9902-2UDX-OM (V1.0)
9902-2UDX Function Menu List and Descriptions
Provides three general-purpose timers that can be
triggered to start, pause, reset, or stop upon event
actions. The state of each timer, in turn, can also be
used to invoke other actions.
Email Alerts
Event Timers 1 thru 3 (Timer 1 shown) can be set with count-down values. The Pause/
Reset/Start control here are manual controls. The timers are typically used with
automated cues to start and stop the timer(s), as shown below.
Provides setup for automated Email alerts when an
event has occurred.
Email Alerts
When fields are filled-in to specify recipient and sender, and
email alert is selected for Event Action on Event Triggers
sub-tab page, recipeient receives an email alert upon event,
with the triggering event shown (in this example, "frozen
video detected").
9902-2UDX PRODUCT MANUAL
3-65