Cobalt Digital Inc 9902-2UDX Product Manual page 112

3
4-Character Alphanumeric Display
Item
Alphanumeric Shows card statuses (BOOT (card booting), (9902-2UDX (card up and OK))
Display
COM LED Blue LED flashes when 9902-2UDX is receiving control message from remote network control (e.g.,
DashBoard™ or Cobalt
REF LED Blue LED illuminates indicating 9902-2UDX is receiving selected reference when set up for framesync
operation.
ERR LED This function is currently reserved.
Input Active Blue LEDs for each SDI input (A thru D) indicate signal presence for each corresponding card SDI input. No
LEDs illumination of any of the LEDs indicates the 9902-2UDX has not locked onto a valid signal on any input.
3-74
9902-2UDX Card Edge Status/Error Indicators and Display
Figure 3-7 shows and describes the 9902-2UDX card edge status indicators
and display. These indicators and the display show status and error conditions
relating to the card itself and remote (network) communications (where
applicable). Because these indicators are part of the card itself and require no
external interface, the indicators are particularly useful in the event of
communications problems with external devices such as network remote
control devices.
9902-2UDX
®
Remote Control Panel)
Figure 3-7 9902-2UDX Card Edge Status Indicators and Display
9902-2UDX PRODUCT MANUAL
Input Active
Status/Error
Indicators
Indicators
Function
Troubleshooting
9902-2UDX-OM (V1.0)