Cobalt Digital Inc 9902-2UDX Product Manual page 119

Operating Instructions
Press and hold MMC BOOT button
1
2 Power-up card and continue holding
button for 3 seconds, then release
button
9902-2UDX-OM (V1.0)
COM LED
Figure 3-11 MMC Boot Button
With button now released, the card will begin reprogramming:
3.
COM
•
When reprogram is complete,
•
again (entire process takes about 1-1/2 minute).
Remove power from the card (remove card from slot or power-down
4.
BBG-1000 Series unit).
Re-apply power to the card. The card/device will display as
5.
"UNLICENSED" in DashBoard/remote control.
In Dashboard or web remote control, go to
6.
Restore from SD Card
be restored and card will be using its most recently installed firmware.
Card/device can now be used as normal. On BBG-1000 Series unit,
7.
re-install top cover.
9902-2UDX PRODUCT MANUAL
FRONT OF CARD
LED illuminates and remains illuminated.
. After about 1/2-minute, the card license(s) will
Troubleshooting
LED turns off, on, and then off
COM
tab and click
Admin
3-81