TP-Link Jetstream L2 TL-SG5412F Installation Manual page 8

JetStream L2 Managed Switch
10/100Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps or 100Mbps.
10/100/1000Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. For
T2500G-10MPS/T2600G-28MPS, the port can also provide power for PDs.
SFP Port
Designed to install the SFP module. For T2500-28TC, the switch features some slots that are shared
with the associated RJ45 ports. The associated two ports are referred as a "Combo" port, which means
they cannot be used simultaneously, otherwise only SFP port works.
Port Feature
Model 10/100/1000Mbps RJ45 Port
TL-SG5412F
T2500G-10TS
T2500-28TC
T2500G-10MPS
T2600G-18TS
T2600G-28TS
T2600G-52TS
T2600G-28MPS
Rear Panel
■
The rear panel is shown as the following figure. Here we take T2600G-28TS as an example.
Figure 1-9 Rear Panel
Kensington Security slot
Kensington Security Slot
Secure the lock (not provided) into the security slot to prevent the device from being stolen.
Grounding Terminal
The switch already comes with lightning protection mechanism. You can also ground the
switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable. For detailed
information, please refer to the Lightning Protection Guide from the training center of our website
http://www.tp-link.com/en/configuration-guides.html.
Power Socket
Connect the female connector of the power cord here, and the male connector to the AC power outlet.
Please make sure the voltage of the power supply meets the requirement of the input voltage (100-240V~
50/60Hz).
Note:
Please use the provided power cord.
■
TL-SG5412F/T2500-28TC does not have a kensington security slot.
■
05 Introduction
10/100Mbps RJ45 Port
12
8
4
8
16
24
48
24
SFP Port
0
0
24
0
0
0
0
0
100-240V~50/60Hz 0.5A
Grounding Terminal
Power Socket
Console Port
4 1
2 2
4 1
2 2
2 2
4 2
4 2
4 2