Error Code List - NEC NC1700L Installation Manual

Appendix

5-2. Error Code List

Please inquire your dealer/distributor about action to be taken for each error code.
Error Code
4 GPSU(12V) Fail
5 Light Unlit
12 EEPROM R Fail
15 EEPROM W Fail
120 DLP Ack Fail
121 Lens Fail
138 ICP CriticalFail
139 ICP PowerOn Fail
141 DLP CommE Fail
151 Fan1 Stop
152 Fan2 Stop
153 Fan3 Stop
154 Fan4 Stop
155 Fan5 Stop
156 Fan6 Stop
157 Fan7 Stop
158 Fan8 Stop
159 Fan9 Stop
165 GPI MACRO(n) Selection Invalid
166 GPI Control Invalid
177 Tamper Fail
178 Marriage Tamper Fail
190 The Validity has expired.
191 Different Serial Number
192 Different Model Code
217 Chiller Filter Cleaning
245 Fan10 Stop
246 Fan11 Stop
247 Fan12 Stop
248 Fan13 Stop
249 Fan14 Stop
251 Fan1 Stop Precaution
252 Fan2 Stop Precaution
253 Fan3 Stop Precaution
254 Fan4 Stop Precaution
255 Fan5 Stop Precaution
256 Fan6 Stop Precaution
257 Fan7 Stop Precaution
258 Fan8 Stop Precaution
259 Fan9 Stop Precaution
264 Fan10 Stop Precaution
265 Fan11 Stop Precaution
110
Error message Description
Power supply is abnormal.
The light source is not on.
EEPROM data read error is detected.
E2PROM data write error is detected.
ICP Firm failed operation.
Lens unit control error
ICP Firm Critical Error
ICP Firm Startup Error
Communication error with the ICP Firm
Fan1 has stopped.
Fan2 has stopped.
Fan3 has stopped.
Fan4 has stopped.
Fan5 has stopped.
Fan6 has stopped.
Fan7 has stopped.
Fan8 has stopped.
Fan9 has stopped.
Selection of preset button (n) through GPI is invalid
because metadata control is enabled.
* This message would be shown on Log, not on LCD.
Projector control through GPI is invalid because metadata
control is busy.
* This message would be shown on Log, not on LCD.
Service door tamper switch of projector is open.
Marriage tamper switch of projector is open.
The time limit for use of the projector has expired.
* In cases when the validity setting has been configured
with the projector
There is a mismtach in the serial number of the main unit
internally saved on the projector.
There is a mismtach in the model code of the main unit
internally saved on the projector.
The time to clean filter (Chiller).
Fan10 has stopped.
Fan11 has stopped.
Fan12 has stopped.
Fan13 has stopped.
Fan14 has stopped.
Fan1 Stop Precaution
Fan2 Stop Precaution
Fan3 Stop Precaution
Fan4 Stop Precaution
Fan5 Stop Precaution
Fan6 Stop Precaution
Fan7 Stop Precaution
Fan8 Stop Precaution
Fan9 Stop Precaution
Fan10 Stop Precaution
Fan11 Stop Precaution