Table of Contents
Advertisement
Install blade guard:
See chapter 7.3
Install rip fence carrier:
Attach the rip fence carrier to the machine table front with
‐ 2 Carriage bolts M6X20
‐ 2 Nuts M6
‐ 2 Washers 6
Install rip fence:
Use 2 bots, 2 washers and 2wing nuts (f, Fig. 9) to attach the
aluminium profile (e) to the rip fence body.
Install rear extension table: Fit the rear table extension (L,
Fig. 10).
Attach two support rods (N, Fig. 11).
Adjust the table to be level and tighten the nuts.
Fig. 8
Fig. 9
Fig. 10
5.3 Dust connection
Before initial operation, the machine must be connected to a
dust extractor. The suction should switch on automatically
when the saw is switched on.
Attach the connecting hose to the saw guard and the Y‐piece
A 100mm dust collection hose can be connected.
5.4 Mains connection
Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a 16A surge‐proof fuse.
Only use connection cables marked H07RN‐F
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
5.5 Starting operation
You can start the machine with the green ON button. The red
OFF‐button on the main switch (C, Fig 1) stops the machine.
6. Machine operation
Correct working position:
In front of the machine standing out of the line of cutting
(danger zone).
Work piece handling:
Hands placed flat on the work piece outside the cutting area.
Feed the work piece towards the saw blade in the direction of
the saw line. Push the work piece steadily forward; complete
the cut as a single movement.
Support long and wide workpieces with helping roller stands.
Operating hints:
Always observe the safety instructions and adhere to the
current regulations.
Ensure that the saw blade protective cover is in the correct
Fig. 11
Advertisement
Table of Contents
