Rearview Camera; Segments In The Visual Display - Audi TT Coupe 2016 Owner's Manual

Parking systems
Swit ching on
.. Shift into reverse, or
.. Press the
PIJ/A
button in the center console
¢ fig. 81. A short confirmation tone sounds and
the LED in the button turns on.
Switching off
.. Drive faster than 6 mph (10 km/h), or
.. Press the
P' # A
button, or
.. switch the ignition off.
Segments in the visual display
The segments in front of and behind the vehicle
(veh icles with parking system plus*)
r::!;>
fig. 82
help you to determine the d istance between yo ur
vehicle and an obstacle. The red lines mark the
expected direction of travel according to the
steering angle. A white segment indicates an
identified obstacle that is outside of the vehicle's
path. Red segments show identified obstacles
that are in your vehicle's path. As your vehicle
comes closer to the obstacle, the segments move
closer to the vehicle. The collision a rea has been
reached when the next to last segment is d is-
p layed. Obstacles in the collision area, includ ing
those outside of the vehicle's path, are s hown in
red. Do not continue driving forward or in reverse
r::!;>
.&.
in General information on page 82,
¢ 0)
in
General information on page 82!
Rearview camera
Introduction
Applies to: vehicles with rearview ca mera
Fig . 83 Diagram: lines to a id in parking
The rearview camera helps you to park or maneu-
ver using the orientation lines.
84
General information
Appli es to: vehicles with rearview camera
Fig. 84 Area covered <!) and area not covered @ by t he
rearview ca mera.
Fi g. 85 Luggage com partment lid: location of the rear-
view camera
The rearview camera is located above the rear li-
cense plate bracket. Make s ure that the lens for
the parking system ¢ fig . 85 is not covered by de-
posits or any other obstructions because th is can
impa ir the f unction of the pa rking system. For in-
format io n on cleaning, refer to
r::!;>
poge 2 70.
The rearview camera coverage area includes ©
¢ fig. 84. Only this a rea is shown in the Infot ain-
ment display. Objects that a re outside of t his
area @ are not displayed.
The accuracy of the orientation lines and the blue
su rfaces is reduced ifthe vehicle is ra ised or ifthe
Dynamic
mode is activated
r=;, page 79 .
.&_
WARNING
- Always read and follow the applicable warn-
ings
r::!;>
&
in General information on
page 82.
- If the posit ion and the installat ion angle of
t he rearview camera was changed, for ex-
ample, after a collision, do not continue to