Parking; Starting From A Stop; Emergency Braking Function; Starting And Automatically Releasing The Parking Brake - Audi TT Coupe 2016 Owner's Manual

Driving
- If driver's door is opened while the ign ition
is switched on, the parking brake sets auto-
matically. This prevents unintended rolling
of the vehicle.
- Occasional noises when the parking brake is
applied and released are normal and are not
a cause for concern.
- When the vehicle is parked, the parking
brake goes through a self-test cycle at regu-
lar intervals. Any noises associated with this
are normal.
- If the . (USA models)
I.
(Cana-
da models) indicator lights or
llJ
indicator
lig ht turn on, there could be a malfunction
in the parking brake
~page
11.
- If there is
a power fa ilure, the parking brake
will not set if it is released, and it will not
release if it is
set~ .&. .
See an authorized
Audi dealer or authorized Audi Service Fa-
cility for assistance.
Parking
.... Press the brake pedal to stop the vehicle.
....
Pull the switch ~
to set the parking brake .
.... Place the selector lever in the P position.
.... Turn the engine
off ~ ,&.
.... Turn the steering wheel when parking on in-
clines so that the wheels will roll into the curb
if the vehicle starts moving.
A
WARNING
- Always take the vehicle key with you when
leaving the vehicle, even for a short period
of time. This applies particularly when chi l-
dren rema in in the vehicle. Otherwise the
children could start the engine, release the
parking brake or operate electrical equip-
ment (e.g. power windows). There is the risk
of an accident.
- When the vehicle is locked, no one - particu-
larly not children should remain in the vehi-
cle. Locked doors make it more difficult for
emergency workers to get into the vehicle,
which puts lives at risk.
62
Starting from a stop
The start assist function ensures that the park-
ing brake is released automatically upon start-
mg.
Stopping and applying parking brake
.... Pull the
switch ~
to set the parking brake.
Starting and automatically releasing the
parking brake
Requirement: the driver's door must be closed
and the driver's safety belt must be fastened.
.... When you press the accelerator pedal, the
parking brake is automatically released and
your vehicle begins to move.
When stopping at a traffic signal or stopping in
city traffic, the parking brake can be applied. The
vehicle does not have to be held with the brake
pedal. The parking brake eliminates the tendency
to creep when a selector lever position is engag-
ed. As soon as you press the accelerator pedal,
the parking brake releases automatically and the
vehicle starts to move .
Starting on slopes
When starting on inclines, the hill start assist
prevents the vehicle from unintentionally rolling
back. The braking force of the parking brake is
not released until sufficient driving force has
been built up at the wheels.
(0
Tips
For safety reasons, the parking brake is re-
leased automatically only when the driver's
safety belt is fastened and the driver's door is
locked.
Emergency braking function
In the event that the conventional brake system
fails or locks.
.... To brake your vehicle in an emergency, pull the
~switch
and hold it pulled.
.... As soon as you release the button or accelerate,
the braking stops. .,..