Table of Contents
Advertisement
Note: An interface can belong to only one group at a time.
Figure 93 Interface Group Configuration
The following table describes the fields in this screen.
Table 69 Interface Group Configuration
LABEL
Group Name
WAN Interface
used in the
grouping
Grouped LAN
Interfaces
Available LAN
Interfaces
Automatically
Add Clients
With the
following DHCP
Vendor IDs
#
VMG1312-B10C User's Guide
DESCRIPTION
Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
Select the WAN interface this group uses. The group can have up to one PTM interface, up to
one ATM interface and up to one ETH interface.
Select None to not add a WAN interface to this group.
Select one or more LAN interfaces (Ethernet LAN, HPNA or wireless LAN) in the Available
LAN Interfaces list and use the left arrow to move them to the Grouped LAN Interfaces
list to add the interfaces to this group.
To remove a LAN or wireless LAN interface from the Grouped LAN Interfaces, use the
right-facing arrow.
Click Add to identify LAN hosts to add to the interface group by criteria such as the type of
the hardware or firmware. See
This shows the index number of the rule.
Section 12.2.2 on page 174
Chapter 12 Interface Group
for more information.
173
Advertisement
Table of Contents
