ZyXEL Communications VMG1312-B10C User Manual page 93

establish a WDS link with access point AP 2, which has a wired Internet connection. When AP 1
has a WDS link with AP 2, the notebook computer can access the Internet through AP 2.
Figure 45 WDS Link Example
A
6.10.9 WiFi Protected Setup (WPS)
Your Device supports WiFi Protected Setup (WPS), which is an easy way to set up a secure wireless
network. WPS is an industry standard specification, defined by the WiFi Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Each WPS connection works between two devices. Both
devices must support WPS (check each device's documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device
to authenticate the other) in each of the two devices. When WPS is activated on a device, it has two
minutes to find another device that also has WPS activated. Then, the two devices connect and set
up a secure network by themselves.
6.10.9.1 Push Button Configuration
WPS Push Button Configuration (PBC) is initiated by pressing a button on each WPS-enabled
device, and allowing them to connect automatically. You do not need to enter any information.
Not every WPS-enabled device has a physical WPS button. Some may have a WPS PBC button in
their configuration utilities instead of or in addition to the physical button.
Take the following steps to set up WPS using the button.
Ensure that the two devices you want to set up are within wireless range of one another.
1
Look for a WPS button on each device. If the device does not have one, log into its configuration
2
utility and locate the button (see the device's User's Guide for how to do this - for the Device, see
Section 6.6 on page
Press the button on one of the devices (it doesn't matter which). For the Device you must press the
3
WPS button for more than three seconds.
Within two minutes, press the button on the other device. The registrar sends the network name
4
(SSID) and security key through an secure connection to the enrollee.
If you need to make sure that WPS worked, check the list of associated wireless clients in the AP's
configuration utility. If you see the wireless client in the list, WPS was successful.
VMG1312-B10C User's Guide
WDS
AP 1
81).
AP 2
Chapter 6 Wireless
93