Removing The Existing Coiled Cord Cable - Motorola MTM800 FuG Installation Manual

5.9.10.1

Removing the Existing Coiled Cord Cable

Procedure:
1 Rotate the locking collar at the base of the microphone in a counterclockwise direction until it
stops.
2 Pull out the cord and away from the base of the microphone.
3 Install the new coiled cord GMKN4072_ in a reverse order of removal.
Part Number: GMKN4072_, Length: 65 cm (2.2 ft)
Figure 76: Pin Assignment of Cable from Accessory Connector to Microphone Housing
Table 65: Pin Assignment of Cable from Accessory Connector to Microphone Housing
To Accessory Connector (left)
1 nc
... ...
11 nc
12 GND (black)
13 EXT_MIC (blue)
14 nc
15 nc
16 nc
17 EXT_PTT (white)
18 nc
19 HOOK (red)
20 nc
... ...
26 nc
Send Feedback
Chapter 5: Connectors and PIN Assignment
To Microphone Housing (right)
1 nc
2 nc
3 PTT (white)
4 EXT_MIC (blue)
5 GND (black)
6 HOOK (red)
7 nc
8 nc
68015000553-KC
115