Table of Contents
Advertisement
Close All Active Telnet Sessions
System utilities
The system utilities can be used only by users with read/write access. You can use
the system utilities by selecting System Utilities Menu on the Main Menu.
Figure 57 shows the available utilities.
Saving applied changes
To permanently save configuration changes either select F4 to save or go to the
System Utilities Menu and select Save Applied Changes, as shown in Figure 57.
Figure 57. Save applied changes
Logging out
When you have finished using the terminal interface, ensure you have saved and
applied all configuration changes before you log out. The terminal interface provides
an orderly way to log out. One way is to use the LOGOUT command on the Main
Menu. Another way to log out is to select System Utilities Menu from the Main
menu, then select Logout as shown in Figure 58 on page 73.
72
8275-416 User's Guide
Specifies if all Telnet sessions are to be Closed or not. Toggle to the
selection (Yes or No) , press Enter, then Apply your selection.
Advertisement
Table of Contents
Troubleshooting
