Table of Contents
Advertisement
Figure 41. Trunk status menu
ifIndex
Trunk interface number (ifIndex) values are fixed at 33 to 40. The interface
number is assigned by the switch and in a range above the numbers of the
ports (for example, ifIndex 33 to 36 is shown on panel 1of 2, and 37 to 40
is shown on panel 2 of 2). This field is not configurable.
Trunk Name
Defines the unique name for the trunk. You can use up to 15 alphanumeric
characters. There is no default trunk name.
Flush Timer
Specifies the time that all trunk ports will be disabled during trunk
transitions. This is done to ensure that frames are not misordered when
flows are re-assigned to new ports. "N/A" indicates the trunk is not
configured. The range of values is 100 to 4000 milliseconds (0.1 second to
4 seconds). The default is 1000 milliseconds (1 second).
Spanning Tree State
Specifies that spanning tree is either Enabled or Disabled for the trunk.
Trunk State
Specifies whether the trunk is Empty, LinkUp, or LinkDown. Empty indicates
the trunk is not configured.
Member Ports
Defines the port numbers associated with a specific trunk.
Chapter 4. Using the Terminal Interface
59
Advertisement
Table of Contents
Troubleshooting
