IBM 8275-416 User Manual page 84

Figure 54. Self Learning IP host address menu
Number of active host entries
IP Address of Host to Display
Host MAC Address
Host Unit.Slot.Port
Host Packets Switched
Router (Gateway) IP Address
Router (Gateway) MAC Address
Notes:
1. When the panel is first displayed, the lines for the Host MAC Address, Router
2. If the specified Host IP address is not found, the message "Information for <IP
68
8275-416 User's Guide
Current number of hosts (IP addresses) identified by the Self Learning IP
function since it was last enabled. This is the same value that is displayed
on the Switch Detailed Statistics Menu.
You specify the IP address of the host for which you want to view
information.
MAC address associated with the host's IP address.
Unit, slot, and port number for this host. If the port is part a trunk, then this
line is labeled "Trunk ifIndex" and the value is the ifIndex for this trunk.
The number of IP packets destined for this host's IP address that were
switched directly to this host address, bypassing the router, since the host
was last learned by the self-learning IP function.
The IP address of the router to which this host communicates when
sending IP traffic to a different subnet (as viewed by the self-learning IP
function).
The MAC address of the router to which this host communicates when
sending IP traffic to a different subnet (as viewed by the self-leaning IP
function).
MAC Address, Host Unit.Slot.Port, and Host Packets Switched are blank. After
the IP Address is entered and Apply is selected, these lines appear.
address> is not available" where <IP address> is the value that was entered for
"IP Address of Host to Display".