IBM 8275-416 User Manual page 44

v Space Bar: Is an allowable key to enter text.
v Tab: Performs the same function as the Enter key.
v F4: Save. Causes the configuration data to be saved and also applied if not
Angle brackets identify an item that can be changed by selecting the desired option.
The following special keys are used while selecting a configuration option:
v Arrow keys: The text is accepted and the cursor moves to the appropriate field
v Enter: The text is accepted and the cursor moves to the next field. On a field
v Esc: Stops modifying the field and restores the original data.
v Space Bar: Displays the next possible value for this field. Use it to cycle through
v Tab: Performs the same function as the Enter key.
v F4: Save. Causes the configuration data to be saved and also applied if not
When processing data entered in a text field, all leading and trailing white-space
characters are ignored (such as, space, Tab, Esc).
Once a configuration change is made and is accepted (the cursor is no longer on
the field that was modified), the change is not put into effect until you select APPLY.
Saving the configuration changes
Note: To help remind you that a configuration change needs to be applied, APPLY
When you select APPLY, the following actions occur:
1. All configuration changes that you made are checked for correct syntax.
2. If you entered invalid configuration data (for example, data value that is out of
3. When the data has been checked and you have corrected any errors,
If you make configuration changes and then exit a panel without applying the
changes, your changes may be lost. For example, the following results in losing any
changes made on the panel:
v You make configuration changes on the current panel and you select any of the
Note: Configuration changes are not automatically retained across a reset or a
28
8275-416 User's Guide
already done.
indicated by the direction of the arrow key pressed. On a field where you have
made no modifications, arrow keys move the cursor to the appropriate field.
where you have made no modifications, Enter moves the cursor to the next field.
the available options to select the desired value.
already done.
always appears on the Command Bar.
the supported range), an error message is displayed identifying the field that
contained the error. Errors are reported one field at a time. All data must be
valid before it can be applied.
UNSAVED DATA is displayed in the upper right corner of the panel.
following commands:
– MAIN MENU
– PREV MENU
power cycle. To retain changes, you must select the Save command as
described in the following section.