ProForm PFBE3006.0 User Manual page 10

14. Insert an M10 x 20mm Bolt (89) into the Weight
Carriage (42) from the side shown.
Slide the Weight Carriage Stop (58) onto the
Rear Upright (41). Then, slide the Weight
Carriage (42) onto the Rear Upright.
15. Attach a Guide Rod (46) to the Left Rack Base
(37) with an M8 x 53mm Bolt (9), two M8
Washers (83), an 11mm x 8mm Spacer (82), and
an M8 Nylon Locknut (78). Do not tighten the
Nylon Locknut yet.
Attach a Guide Rod (46) to the Right Rack
Base (38) in the same manner.
16. Attach a Barbell Stop Hook (48) to a Barbell Stop
(47) with an M10 x 25mm Bolt (88) and an M10
Nylon Locknut (77). Do not tighten the Nylon
Locknut yet; the Stop Hook should pivot easily.
Slide a Bumper (4) and the Barbell Stop (47) onto
the right Guide Rod (46).
Identify the Right Barbell Guide (53) by the loca-
tion of the screw hole. Slide the Right Barbell
Guide onto the right Guide Rod (46).
Repeat this step with the left Guide Rod (not
shown).
14
42
58
15
38
46
16
Screw
Hole
77
48
4
10
89
41
46
9
83
83
78
53
47
88
46
37
82