Log Messages - Medivators DSD-201 Service Manual

Log Messages

Add Air.............................Indicates that an add air cycle was run.
Add Air On .......................Indicates that as Add Air cycle will be added at the end of the current cycle.
Add Air Off ......................Indicates that as Add Air cycle will not be added at the end of the cur rent cycle.
Air ....................................Notes when the air portion of a cycle occurred.
Attach Restrictor ..............Prompts the user to attach the restrictor adapter.
Auto Dis. ..........................Indicates that an auto water line disinfectant cycle was run.
Disinfect ...........................Notes when the disinfectant portion of a cycle occurred.
Dump Dis. ........................Indicates that a dump disinfectant cycle was run.
Load Dis. ..........................Indicates that a load disinfectant cycle was run.
Low Alcohol ....................Indicates that the alcohol level is low.
Machine ID ......................The serial number of the SSD-102.
No Air Flow ....................Indicates that no air flow was detected.
No Fluid Flo .....................Indicates that no fluid flow was detected.
Operator ..........................Enter the operator ID number.
Patient ............................Enter the patient ID number.
Physician ..........................Enter the physician ID number.
Power on ..........................Indicates that the device lost power during a cycle.
Res T High .......................Indicates that the temperature of the reservoir has exceeded the maxi mum
Res T Low ........................Indicates that the temperature of the reservoir is below the minimum for save
disinfection.
Resume .............................Indicates when a cycle was resumed.
Rinse 1 .............................Notes when the Rinse 1 portion of a cycle occurred.
Rinse 2 .............................Notes when the Rinse 2 portion of a cycle occurred.
Rinse 3 .............................Notes when the Rinse 3 portion of a cycle occurred.
S/N ...................................Indicates the machine serial number.
Scope ................................Enter the scope ID number.
Sheath Fail ......................Indicates that the sheet test failed.
Sheath Test .......................Notes when the sheath test portion of a cycle occurred.
Shth Sen Err .....................Indicates that the sheet tester measured pressure at the start of a cycle.
Start ..................................Indicates when a cycle was started.
Sth Disabled .....................Indicates that the sheath (leak) tester was disabled.
Stop ..................................Indicates when a cycle was manually stopped.
Temp = ............................Indicates the basin temperature at the beginning and end of the disin fect phase.
152