Medivators Advantage Hookup Connection Manual

2-8-338
HOOKUP CONNECTION GUIDE
Using MEDIVATORS ® ADVANTAGE ® Automated Endoscope Reprocessors

ADVANTAGE HOOKUP DIAGRAM


Medivators Inc.
14605 28th Ave N.
Minneapolis, MN 55447
Ž
USA
Medivators BV
Sourethweg 11
6422PC Heerlen
The Netherlands

Œ
Each ADVANTAGE Hookup is comprised of multiple ports and connector assemblies.
Each port is labeled with a Port ID number (circled). This same number also identifies the
corresponding Connector Assembly.

CONNECTOR ASSEMBLY IDENTIFICATION CHART

Port ID Port Name Connector Assembly Description
 LEAK TEST Leak Test Connector Assembly
 JET/AUX Air/Water Connector Assembly
 BIOPSY Biopsy Inlet Connector Assembly
 AIR Air Probe Connector Assembly
 ELEVATOR Auxiliary Water Connector Assembly
 WATER Air/Water Connector Assembly
SUCTION Suction Connector Assembly

 EXTRA Balloon Connector Assembly
If a Connector Assembly needs replacement, locate the port number/name and use
the corresponding order number found in the chart above. Connector Assemblies are
specific to individual hookups.
If you have any questions regarding this hookup, in the U.S., please contact Medivators
Technical Support at 1-800-444-4729. Outside the U.S., please contact your Medivators
Distributor.
© 2015 Medivators Inc. 50098-1019-EN/A

‘
’
“
Balloon Connector
Align stainless steel fitting with
balloon port, push and turn
clockwise to connect.

Order Number
H28338-1
N/A
H28338-3
N/A
N/A
N/A
H28338-7
H28338-8
DESIGNATED HOOKUP FOR THE FOLLOWING FUJIFILM™ ENDOSCOPES*:
EB-530US
* This list of corresponding endoscope models is subject to change without notice. For a full list, please go to:
www.medivators.com/hookuplookup
Representative endoscope for illustrative purposes only. For exact
port locations, refer to endoscope manufacturer's instruction guide.
Ensure Biopsy Connections are correct to avoid alarms.
READ ALL INSTRUCTIONS PRIOR TO CONNECTION
Locate the endoscope port and follow the instructions for attaching the
corresponding Endoscope Connector. All connectors must be attached.
Suction Connector
Align stainless steel fitting
with Fujinon Cleaning
Adaptor, push and turn
clockwise to connect.
FUJIFILM
Cleaning Adaptor

WA-001
Refer to FUJIFILM User
Manual for connection
instructions

FUJIFILM Cleaning
Adaptor WA-003
Refer to FUJIFILM User
Manual for connection
instructions
Biopsy Inlet Connector
Align stainless steel fitting with
Fujinon Cleaning Adaptor, push
and turn clockwise to connect.

Leak Test Connector
Align pins on connector with slots
on the scope. Push on and turn
clockwise to engage.