Finalizing The Transducer Mounting - Raymarine Dragonfly-4 DV Installation And Operation Instructions Manual

4.5 Finalizing the transducer mounting

Once you have achieved optimum performance at
the desired vessel speeds the transducer must be
locked into position to complete the installation.
1. Drill the locking hole location taking care not to
damage the mounting bracket.
2. Fill the locking hole with marine grade sealant.
3. Secure the transducer and bracket by fully
tightening all 3 mounting screws.
4. Secure the ratchet arm bolt, by tightening until
the compression washer is compressed and then
add another 1/4 turn. If the transducer kicks up at
speed then tighten further.
Important: Take care to ensure that the pivot bolt
is not overtightened as this will prevent kick-up
and may cause damage.
Mounting
D13197-1
33