Wi-Fish ™ Initial Set Up - Raymarine Dragonfly-4 DV Installation And Operation Instructions Manual

6.4 Wi-Fish ™ initial set up
Once the Wi-Fish ™ unit is installed and connected
to your smart device, which is running the latest
version of the Wi-Fish
the following tasks are completed:
• Configure units of measure for depth and
temperature readings
• Set a transducer offset
• View the app's Help pages
• Familiarize yourself with the product using
Simulator Mode.
These options are available in the Wi-Fish
app's More menu which includes the following
settings:
• Settings
– Transducer depth offset
– Depth units
– Temperature units
– Simulator
• Help
• About
.
46
™ app, it is recommended that
™
6.5 Depth Offset
Depths are measured from the transducer to the sea
bed, but you can apply an offset value to the depth
data, so that the displayed depth reading represents
the depth to the sea bed from either the keel or the
waterline.
Before attempting to set a waterline or keel
offset, find out the vertical separation between the
transducer and either the waterline or the bottom of
the keel on your vessel, as appropriate. Then set the
appropriate depth offset value.
mobile
1
1
2
3
If an offset is not applied, displayed depth readings
represent the distance from the transducer to the
sea bed.
Assigning a transducer depth offset —
Wi-Fish ™ app
Follow the steps below to assign a depth offset value
to your depth readings.
With the Wi-Fish
running on your smart device:
1. Select the More icon (three vertical dots).
2. Select Settings.
3. Select Transducer Depth Offset.
4. Adjust the depth offset to the required value.
2 3
Waterline offset
Transducer / Zero offset
Keel offset
™ mobile app connected and
Dragonfly–4 / Dragonfly–5 / Dragonfly–7 / Wi–Fish
D9343--2