Chapter 2: Installation
9. As soon as the boat is placed in the water, check for leaks. Check
again within 3 to 5 hours. (You may not be able to see a small leak
right away.) If there are any leaks, you must repeat the installation
procedure.
Paddle wheel
assembly near
rear.
Fig. 2-5 Mounting the Transducer Correctly
Assembling the Transducer Bracket
Follow these instructions if you are installing the transom-mount
transducer.
Fit together the two parts of the transducer bracket as shown in Fig. 2-6.
When the installation is complete, the parts snap together as shown.
Fig. 2-6 Assembling the Transducer Bracket
LIKE THIS!
Attach the
two parts
Lower the transducer
and snap in the
release clip
This end forward
NOT THIS!
Bracket is installed
upside down
11