Toshiba Strata VI Installation Instructions Manual page 22

0
0
0
~[
0
0
0
0
00
!RT K~U
0 0
00
1---t:J-----,-'a i
0
0
FIGURE 28
the two MOH terminals on the MTOU
barrier strip. Input impedance is 600
ohms.
11.20 MusiC-On-Hold Volume Control
11.21 Adjust the MOH volume with
the
MOH
volume control on the front
of the MTOU. Maximum volume is
limited by internal circuits in order to
comply with FCC regulations. See
Paragraph 11.80 for the correct volume
setting sequence.
11.30 External Paging Connectiom
11.31 The STRATA VI provides ac-
cess to an external paging system by
dialing a single digit (7). The single
output connection is made via the
8/600 terminals on the front of the
MTOU terminal, and can be used in one
of three ways:
a) To operate a
speak er directly,
3-watt amplifier
MTOU PCB.
customer-provided
via an internal
located on the
b) If more than 3 watts are required,
an external customer-provided amp-
lifier can be connected to operate
the external speaker.
SECTION 100-006-200
INSTALLATION INSTRUCTIONS
DECEMBER 1982
c) If talk-back capability is required,
a customer-provided talk-back amp-
lifier /speaker can be connected.
NOTE:
See Paragraph
correct volume
quence.
11. 80
for
the
setting
se-
11.40
nee ti on
Direct External Speaker Con-
11.41 The exact number of speakers
that may be connected to the 8-ohm,
3-watt output will depend on the type
of speak er used, the conductor resis-
tance, and the desired volume.
11.42
The 8-ohm output impedance
must be selected with the SW 2 switch
on the MTOU (Figure 29). The switch
must be on the side labeled
11
8
11 •
FIGURE 29
11.43 Connect the external speaker
to the two 8/600 terminals on the
MTOU PCB.
11.44
Adjust the speaker volume
with the
EX.SP
volume control on the
front of the MTOU. See Paragraph
11.80 for the correct volume setting
sequence.
11.50 External Amplifier Connection
11.51
If more power is required
- 19 -