Toshiba Strata VI Installation Instructions Manual page 20

tions and confirm the proper func-
tioning of the EKT itself. Refer to
Figure 27, and perform the following
test procedure at each station. Begin
with Ext. 10.
)1ra ....,.,..
-:ootlllOl.ll!
c:::J c::J CJ CJ
FIGURE 27
10.03
With handset on-hook:
•
Operate
[]!IT]]
key
INT 1 LED:
I-use flash
SPKR LED:
on steady
Listen for INT dial tone via
EKT speaker
•
Adjust speaker volume
with the
volume control on the rear right
side of the EKT.
• Operate INI2 key
INT
2
LED: I-use flash
SPKR LED: on steady
Listen for INT dial tone via
EKT speaker
• Operate
~
key
CO 1 LED: I-use flash
SPKR LED: on steady
Listen for CO/PBX dial tone
via EKT speaker
• Dial any digit
(2 -
9) on the dial
pad and dial tone will stop.
- 17 -
SECTION 100-006-200
INSTALLATION INSTRUCTIONS
DECEMBER 1982
e Operate
[MW/FL
I key
Listen for circuit break fol-
lowed by dial tone after ap-
proximately 2 seconds.
• Operate
fCT[2l
key
CO 1 LED: I-use flash
SPKR LED: on steady
Listen for CO/PBX dial tone
via EKT speaker
NOTE:
If no CO /PBX facility is con-
nected
to a
CO key, dial
tone will not be heard but
the LED is still functional.
• Operate
ICIT]l
key
CO 3 LED: I-use flash
SPKR LED: on steady
Listen for CO/PBX dial tone
via EKT speaker
• Operate
~
key
CO 4 LED: I-use flash
SPK R LED: on steady
Listen for CO/PBX dial tone
via EKT speak er
• Operate
~
key
CO 5 LED: I-use flash
SPKR LED: on steady
Listen for CO/PBX dial tone
via EKT speaker
• Operate
~
key
CO
6
LED: I-use flash
SPK R LED: on steady
Listen for CO/PBX
dial
tone
via EKT speaker
• Operate ISPKR I key
SPKR LED: off
EKT speaker: off
•
Operate ON:Q key
DNO LEO: on
• Operate
c:ND
key
DND LED: off