Toshiba Strata VI Installation Instructions Manual page 19

SECTION 100-006-200
INSTALLATION INSTRUCTIONS
DECEMBER 1982
0
"4COlJ
-Mrt
01
Ot
01
Oi O•
FIGURE 26
d) Depress and release the SET switch
again.
e) Release the INT switch.
f)
Cycle the MTOU power switch OFF
and
ON.
09.10 The Automatic Dialing memory
will conti:l.in random numbers when the
system is powered up initially. To
clear the memory; therefore preventing
meaningless numbers from being dialed,
proceed as follows:
a) To clear Automatic Dial-System
memory
(24
numbers):
e Lock in the SET switch on the
MCCU-the MCCU LED and the
MW/FL LED on Ext. 17 will be
on.
e Operate the
LS1'K.RJ
key on Ext.
17-SPKR LED will be on
steadily.
c Dial
00 0 0
on the dial
pad-the SPKR LED will flash
continuously.
(' ) Operate the following keys:
0
0
aNlJl
lCID &:IT:J
~-the
responding LEDs will
steadily.
cor-
light
e Operate the
IHOLDI
key-all Ext.
17 LEDs (except MW /FL) will
go off.
• Release the SET switch on the
MCCU-the MCCU LED and the
MW/FL LED on Ext. 17 will go
off.
b) To clear the optional Automatic
Dial-Station memory:
e Lock in the SET switch on the
MCCU-the MCCU LED and the
MW /FL LED on Ext. 17 will go
on.
• Operate the
ISPKR I
key on Ext.
17-the SPKR LED will be on
steadily.
• Dial
0 0
Won the dial pad-
SPKR LED will flash continu-
ously.
• Operate the following keys:
lffIT2 fCQ2l ~ ~the cor-
responding LEDs will light.
• Operate the
IHOLDI
key-all Ext.
17 LEDs (except MW /FL) will
go off.
• Release the SET switch on the
lVlCCU-the MCCU LED and the
MW /FL LED on Ext. 17 will go
off.
09.11 If the appropriate preceeding
sequence fails, refer to Section 100-
006-500, Fault Finding Procedures, for
assistance in locating the fault.
10 SYSTEM TEST PROCEDURES
10.01 EKT Functional Check
10.02 Verify the basic system func-
- 16 -