Toshiba Strata VI Installation Instructions Manual page 17

SECTION 100-006-200
INSTALLATION INSTRUCTIONS
DECEMBER 1982
has the same overall dimensions as the
standard EKT, and is installed in
exactly the same manner. See Program
5XX in Section 100-006-300, Program-
ming, for inputting information con-
cerning the 20-key. It is equipped with
10 additional feature keys-see Section
100-006-100, General Description, for
additional information.
08.10 EKT Wall Mounting
08.11 An optional handset hanger
kit is required to convert either type
of EKT for wall mounting. The EKT
may be mounted on a wall or any other
flat, vertical surf ace to which the base
can be secured.
08.12 When selecting the mounting
site, consider the EKT weight and the
additional stresses to which the
mounting will be subjected.
08.13
Mounting screws or mollies,
appropriate for the surf ace on which
the telephone is to he secured, must be
provided by the installer.
08.14 Locking tabs secure the base
to the EKT. The direction in which
the base is attached to the EK T de-
termines whether it will be used as a
desk unit or wall unit (it is factory-
configured as a desk unit). Disengage
the locking tabs by pushing downward
on the base (Figure 21).
FIGURE 21
08.15
Refer to Figure 22, choose
which of the choices are appropriate
for the tail cord route, and then cut
them.
FIGURE 22
08.16
Secure the base to the de-
sired wall site. Use a spirit level and
make certain the top of the base is
level and that the deeper portion is
down.
08.17
Route the tail cord through
the holes in the base and secure the
EKT (Figure 23). Test the sturdiness
of the EKT mounting.
FIGURE 23
0 8.20 Converting the EKT
08.21
Refer to Figure 24, the op-
- 14 -