Toshiba Strata VI Installation Instructions Manual page 18

tional handset hanger kit (available
from your Toshiba supplier) must be
used whenever the EKT is wall-mounted.
Handset
Hanger
Nurnber Card
Card Cover
FIGURE 24
08.22 Remove the card cover by in-
serting a paper clip in the hole at one
end. Bend the cover up and remove it
and the number card.
08.23
Install the handset hanger
in to place and tighten the self-tapping
screws. Reinstall the number card and
card cover and connect the modular
plug to the modular jack.
09 SYSTEM POWER-UP INITIALIZE
09.01 The STRATA VI has a list of
standard system data assignments stored
in ROM that can be entered at any
time by performing the initialize
sequence outlined below. The system
must be initialized when it is first
installed or whenever the MCCU PCB
is changed. This will allow the system
to be tested and any faults to be
corrected before time is spent on
programming.
SECTION 100-006-200
INSTALLATION INSTRUCTIONS
DECEMBER 1982
NOTE:
Do not initialize if using a
pre-programmed, battery-pro-
tected HCCU.
09.02 Ref er to Figure 25 and verify
that the battery on the MCCU (and
CRDU, if equipped) is connected to
ensure that data changes entered after
initialization will not be lost due to
power failure.
NOTE:
The SET LED will not func-
tion if the MCCU battery is
not connected.
Sl'.3 BATTERY STR,\P
SW! BATTERY STRAP
FIGURE 25
09.03 To initialize the system data
memory, ref er to Figure 26 and perform
the following steps:
a) Place
the power switch on
the
MTOU PCB in the
ON
position.
b) Depress the
INT
switch
on the
MCCU, and hold it in.
c) Depress the SET switch and allow
it to lock.
- 15 -