GPX PJ608 User Manual page 19

–
Power supply or power cord is
damaged.
• Do not use the projector in places where
flammable gases or explosives may be
present.
• Do not use the projector in the following
conditions:

–
Extremely hot, cold, or humid
environments

–
Environments with excessive amounts
of dust and dirt in the atmosphere.

–
Near appliances generating a strong
electromagnetic field or heat.

–
In direct sunlight.
• If the air vents become clogged or dirty, use
a vacuum or air compressor and nozzle to
clean. Do not use canned air, as the gas may
leave a residue inside the enclosure.
• CAUTION: TO PREVENT ELECTRIC
SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
• Mains plug is used as disconnect device and
it should remain readily operable during
intended use. In order to disconnect the
apparatus from the mains completely, the
mains plug should be disconnected from the
mains socket outlet completely.
• CAUTION: Use of controls or adjustments
or performance of procedures other than
those specified may result in hazardous
radiation exposure.
• WARNING: Changes or modifications to
this unit not expressly approved by the
party responsible for compliance could
void the user's authority to operate the
equipment.
• WARNING: Use of this unit near
fluorescent lighting may cause interference
regarding use of the remote. If the unit is
displaying erratic behavior move away
from any fluorescent lighting, as it may be
the cause.
• WARNING: Shock hazard - Do Not Open.
• Caution and marking information is located
at the rear or bottom of the apparatus.
• WARNING: To reduce the risk of fire or
electric shock, do not expose this apparatus
to rain, moisture, dripping, or splashing.
• Objects filled with liquids, such as vases,
shall not be placed on the apparatus.
• Do not place any objects, heavy or
otherwise, on the projector.
• This product meets and complies with all
Federal regulations.
• See projector enclosure for related safety
markings.
• No user serviceable parts inside, do not
attempt to open the unit or perform any
repair. Doing so may cause damage or
injury, and will void your warranty.
• Refer all repairs or replacement to qualified
service personnel.
• Stop using the projector and unplug the
power source immediately if you notice the
following:

–
Smoke coming from the unit or power
supply.

–
Strange odors or noises coming from
the unit.

–
Liquid or foreign objects have gotten
inside the unit.

–
Unit has been dropped and enclosure
has been damaged.
19