GPX PJ608 User Manual page 18

receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
BATTERY WARNINGS
• WARNING: Do not ingest battery,
Chemical Burn Hazard.
• If the remote control supplied with
this product contains a coin/button cell
battery and the coin/button cell battery is
swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
• Keep new and used batteries away from
children. If the battery compartment does
not close securely, stop using the product
and keep it away from children.
• If you think batteries might have been
swallowed or placed inside any part of the
body, seek immediate medical attention.
• CAUTION: Danger of explosion if battery
is incorrectly replaced. Replace only with
the same or equivalent type.
• WARNING: There is a danger of explosion
if you attempt to charge standard Alkaline
batteries in the unit. Only use rechargeable
NiMH batteries.
• Battery shall not be exposed to excessive
heat such as sunshine, fire, or the like.
• Do not mix old and new batteries.
• Completely replace all old batteries with
new ones.
• Do not mix alkaline, standard (carbon-
zinc), or rechargeable (ni-cad, ni-mh, etc)
batteries.
• Batteries should be recycled or disposed of
as per state and local guidelines.
18
ADDITIONAL WARNINGS
AND PRECAUTIONS
• Do not look directly into the projector light.
• Use in well ventilated area with ambient
temperature between 41°F~104°C
(5°C~40°C).
• Do not block any ventilation openings.
• To prevent risk of overheating, place the
projector in an area that does not block
ventilation, such as an enclosure or cabinet
that might restrict airflow.
• Do not place the projector on an unstable
surface, such as a loose stack of books, bed,
or cushion.
• Do not cover the projector with a blanket,
curtain, or similar.
• If setting up near a wall, leave at least 10 in.
(25cm) between the wall and the projector's
ventilation ports.
• Use a power outlet that can be easily
accessed and unplugged.
• Do not block the light coming out of the
lens. The light will heat the object and may
cause burns, cause it to melt or catch fire.
• When powering off the projector, allow the
cooling cycle to finish before handling or
disconnecting the power supply.
• Do not use the projector if it has been
damaged. Damage could be (but not
limited to):

–
Unit has been dropped or something
has been dropped on it or into it.

–
Something is loose or rattling inside
the unit.

–
Projector has been exposed to rain
or liquid.