Jenn-Air JID4436ES Installation Instructions Manual page 13

3. Using a T20 TORX driver, remove the 11 screws that attach
® ®
the panel and motor assembly to the right side of the blower
motor assembly housing. Remove the panel and motor
assembly from the blower motor assembly housing.
A
D
B
A. Left cover plate
B. Blower housing assembly
C. Housing exhaust plate with blower motor
D. Screws (11 for each plate)
4. Reassemble the panel and motor assembly onto the left side
of the blower motor assembly housing. Install the 11 screws
and tighten.
5. Reconnect the 9-pin blower motor electrical connector.
6. Reassemble the left side panel to the right side of the blower
motor assembly housing. Install the 11 screws and tighten.
D
C
A. Left cover plate
B. Blower housing assembly
C. Housing exhaust plate with blower
motor (left exhaust)
D. Screws (11 for each plate)
7. Assemble the 2-piece telescoping rectangular vertical duct
to the blower motor assembly top duct extension. Secure
with screw and metal duct tape.
A. Telescoping rectangular duct (2 pieces)
B. M4 x 9.5 mm screw
C. Blower motor assembly top duct extension
C
B A
A
B
C
Install Blower Motor Assembly
Style 1 – Vented Installations to the Right
(Use "Style 1 – Cabinet Cutouts for Vented Installations" in the
"Cutout Dimensions" section for running vent through the back
or floor of the cabinet.)
1. Set blower motor assembly onto the cabinet floor and align
it to the 90° elbow from the cooktop assembly.
D
A
A. Exhaust opening – blower motor assembly
(towards right side of cabinet)
B. Blower motor assembly
C. Cabinet floor
D. 90° elbow
2. Extend inner section of telescoping rectangular vertical duct
to fit over 90° elbow from cooktop assembly. Secure with
M4 x 9.5 mm screws.
D
B
A. 90° duct to cooktop assembly
B. M4 x 9.5 mm screws (4)
C. Upper vertical duct
D. Lower vertical duct
3. Loosen the 3 screws that secure the 90° elbow if
adjustment is needed. Adjust the ducting and tighten
all of the screws connecting the ducts.
B C
A
B
C
D
D
13