Jenn-Air JID4436ES Installation Instructions Manual page 11

1. Using 2 or more people, place cooktop into the cutout.
2. Align cooktop to sit flat onto the countertop.
3. Install 4 M5 x 50 mm cap screws, lock washers, and flat
washers (1 each corner) to secure the cooktop to the
mounting brackets. Tighten screws to pull cooktop tight
to the countertop.
A
A
B
C
C
D
D
B
E C
F
E
A. Cooktop
B. Cooktop vent slots
C. Countertop
D. Mounting brackets (4)
E. M5 x 50 mm cap screws, lock
washers, and flat washers (4 each)
F. Cabinet (shown with front removed)
G. Cutout location in cabinet floor
(for recirculation installations only)
NOTES:
Make sure that the front edge of the cooktop is parallel to
■
the front edge of the countertop. If repositioning is needed,
lift entire cooktop up from the cutout to avoid scratching
the countertop.
Do not block vent slots on the front of the cooktop.
■
Install Cooktop and Blower Motor Assembly
G
F
Install Mounting Feet/Spacers to Blower
Motor Assembly
1. Install the mounting feet (2) to the bottom of the blower
motor assembly, using 2 M5 x 10 mm flat-head screws
per foot, and tighten.
A
B
C
A. Blower motor assembly front side
B. Mounting feet (2)
C. M5 x 10 mm screws - flat head (4)
Prepare Blower Motor Assembly
Style 1 – Vented or Recirculation to the Right
1. Assemble the 2-piece telescoping rectangular vertical duct
to the blower motor assembly top duct extension. Secure
with screw and metal duct tape.
A. Telescoping rectangular duct (2 pieces)
B. M4 x 9.5 mm screw
C. Blower motor assembly top duct extension
A
B
C
11