Charge Info; Minute Beep - Siemens S2588 Service Manual

14.09.99 S25-gb.fm
42

&RQWURO8VH
Select
required function:
---------------------------------------------------------------
/LQH
&DOO7LPH
&KDUJH6HWXS
3,1RQRII
/LPLW3KRQH
1HWZ%DUULQJV
8VHU*URXSV
---------------------------------------------------------------
Line
If you subscribe to a second phone
line, you can switch lines. It may be
more convenient to assign a soft key
for this, see p. 46.
You may lock the phone so that only
one outgoing line can be used. You will
be asked for PHONECODE, please see
restrictions.
Call Time
You can see the duration of your last
call, and total calls (outgoing and also
incoming). You can also reset these.
If the network indicates the call units
used, they will also displayed, together
with cost, if you have set this, see
below.
S25, A31008-H3100-A1-3-7619
englisch,
Control Use
Charge Setup
then

Charge Info

Your network may provide 'Advice of
Charge' enabling you to see actual
units used. You may need to register
for this service. You can program the
cost per unit, and your phone will cal-
culate and display related charge.
Charge Limit
If you are using prepaid service, your
,
residual credit may be displayed after
each call. You will be advised when
credit is almost finished - prior to serv-
ice termination. Please contact your
Service Provider to renew your credit.
If you have a special SIM, and sub-
scribe to 'Advice of Charge', you may
enter a limited number of units, after
which service will be suspended. The
limit can be adjusted, or switched off
using PIN 2.
,
Combined In/Out
Enables you to set Call Time (Charge)
display to show total calls.
Charge Incoming
Enables setting of separate rate, rele-
vant where incoming calls are charged.
Auto Display
Set to see Time (Charge) display briefly
after every call.

1 Minute Beep

Set to hear an elapsed time reminder
during your calls.
,
,
(Prepaid)