Procom ML150HPA Owner's Operation And Installation Manual page 8

Attaching Mounting Bracket to
Wall
Note: Wall anchors,
screws, and spacers
hardware package. The
package is provided
Attaching to Wal l Stud Method
For attaching mounting bracket to
wall studs
1. Drill holes at marked locations
"
using 9/64 drill bit.
2. Place mounting bracket onto
wall. Line up last hole on each
end of bracket with holes drilled
in wall.
3. Insert mounting screws through
bracket and into wall studs.
4. Tighten screws until mounting
bracket is firmly fastened to
wall studs.
Attaching to Wall Anchor
Method
For attaching mounting bracket to
hollow walls (wall areas between
studs) or solid walls (concrete or
masonry)
1. Drill holes at marked locations
"
using 5/16 drill bit. For solid
walls (concrete or masonry), drill
"
at least 1 deep.
2. Fold wall anchor as shown in
Figure 9 below.
Figure 9 - Folding Anchor
3. Insert wall anchor (wings
first) into hole. Tap anchor
flush to wall.
"
4. For thin walls (1/2
insert red key into wall
anchor. Push red key to
" "
pop open anchor wings
(see Figure 10).
INSTALLATION
hammer
mounting
(over 1/2
are in
do not pop open wings.
hardware
with heater.
Figure 10 - Popping Open Anchor
Wing For Thin Walls
5. Place mounting bracket onto
wall. Line up last hole on
each end of bracket with wall
anchors.
6. Insert mounting screws through
bracket and into wall anchors.
7. Tighten screws until mounting
bracket is firmly fastened to wall.
Placing Heater on Mounting
Bracket
1. Locate two horizontal slots on
back panel of heater (see
Figure 11).
2. Place heater onto mounting
bracket. Slide horizontal slots
onto
mounting bracket.
Figure 11 - Mounting Heater Onto
Mounting Bracket
Inst alling
or less),
Screws
1. Locate two bottom mounting
holes. These holes are near
bottom
heater(see Figure 12).
IMPORTANT: Do not
key! For thick walls
"
thick) or solid walls,
stand-out tabs on
Botto m Moun ting
on back panel of
8
Figure 12 - Installing Bottom
Mounting Screws
2. Mark screw locations on wall.
3. Remove heater from mounting
bracket.
4. If installing bottom mounting
screws into hollow or solid wall,
install wall anchors.Follow steps
1 through 4 under
To Wall Anchor Method. If
installing bottom mounting
screw
into wall stud, drill holes
marked locations using 9/64
drill bit.
5. Replace heater onto mounting
bracket.
6. Place spacers between bottom
mounting holes and wall anchor
or drilled holes.
7. Hold spacer in place with one
hand. With other hand, insert
mounting screw
bottom mounting hole
spacer. Place tip of screw in
opening of wall anchor or drilled
holes .
8. Tighten both screws until heater
is firmly secured to wall. Do not
over tighten.
l Note: Do not replace lower front
panel at this time. Replace lower
front panel after making
connections and checking for
leaks (see pages 9 and 10).
Attaching
at
"
through
and
gas