Procom ML150HPA Owner's Operation And Installation Manual page 7

WARNING: Maintain the
minimum clearanc es
i n F i g u r e 4 . If
provide greater clearances from
floor, ceiling, and joining wall.
Figure 4 -Mounting Clearances As
Viewed From Front Of Heater
IMPORTANT:
heaters add moisture to
air. Although this is beneficial,
installing heater
without enough ventilation air
may cause mildew to
from too much moisture. See
Fresh Air for Combustion and
Ventilation, pages 4 and 5.
INSTALLING THERMOSTAT
SENSING BULB
For T-Stat Models Only
1. Pull out the sensing bulb from the
two clips located in the shippng
position according to the direction
as shown by the arrow. There is no
need to take out the two bulb clips.
2. Take out the bulb clip from the
hardware package and insert it into
the square hole and then insert the
sensing bulb into the bulb clip (see
Figure 5).
Figure 5 - Moving Thermostat
Sensing Bulb
INSTALLATION
FASTENING HEATER TO WALL
Mounting Bracket
s hown
The mounting bracket is located
yo u c a n ,
on back panel of heater (see
figure 6). It has been taped there
for s hipping. Rem ov e m ounting
bracket from back panel.
Figure 6 -Mounting Bracket
Removing Lower Front Panel Of
Heater.
1. Remove two screws near
bottom corners of front panel.
2. Pull bottom of lower front panel
Vent-free
forward, then down (see Figure
the
7).
in room s
form
Figure 7 - Removing Lower Front
Panel of Heater
Methods For Attaching Mounting
Bracket To Wall
Only use last hole on each end
of mounting bracket to attach
bracket to wall. These two holes
are 16 inches apart from their
c e n t e r s .
bracket to wall only in one of two
ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud: This
method provides the strongest
hold. Insert
through mounting bracket and
into wall studs.
Location
A t t a c h m o u n t i n g
mounting screws
7
Attaching to Wall Anchor: This
m ethod allows you
mounting bracket to hollow walls
(wall areas between studs) or to
solid walls (concrete or masonry).
Decide which method
suits your needs. Either method
will provide a secure hold for the
mounting bracket.
Marking Screw Locations
1. Tape mounting bracket to wall
where heater will be located.
Make sure mounting bracket is
level.
WARNING:
minimum clearances shown in
Figure 8. If you can, provide
greater clearances from floor
and joining wall.
2. Mark screw locations
wall. (see Figure 8)
Note: Only mark last hole on
each end of mounting bracket.
Insert mounting screws through
these holes only.
3. Remove tape and mounting
bracket from wall.
Model ML250HPA ML250TPA
Model ML150HPA ML150TPA
Figure 8 - Mounting Bracket
Clearances
to attach
better
Maintain
on