Parameter Editing - Elektron Digitone Quick Manual

[YES] is used to affirm, select, enter sub-menus and tick/untick boxes.
[NO] is used to negate, deselect or go back one or more steps.

4.2 PARAMETER EDITING

The DATA ENTRY knobs are used to change the values of the track parameters. The po-
sitions of the parameters on the screen correspond to the physical locations of the knobs
on the front panel.
• The parameters are adjusted in larger increments if you press down the DATA ENTRY
knob while turning it. This function makes it quicker to sweep through the whole param-
eter range.
• Press DATA ENTRY knob + [NO] to reset the parameter to the default value.
• Press [PARAMETER] + [FUNC] + [PLAY] to reset all the parameters on the selected
parameter page to default values.
• Press and hold a [PARAMETER] key to see the exact values of the parameters.
4.3 PARAMETER VALUE JUMP
Pressing [FUNC] while editing certain parameters makes the parameter values jump to
appropriate positions. The time of the Delay, for example, doubles and halves the value.
4.4 [FUNC] KEY PRESS COMBINATIONS
The standard way to use the [FUNC] key in combination with other keys, is to press and
hold [FUNC] and then press the second key in the combination. For some key combina-
tions, it is also possible to access a sub-menu by pressing and holding [FUNC] + second
key for a second.
4.5 QUICK SCROLLING
Scroll through menus using the LEVEL/DATA knob. Quick scrolling is possible on many
menus. Press [FUNC] + the [UP] or [DOWN] keys to move the cursor one menu page.
18