Lcd Display And Indicators - Printek 4000se Operator's Manual

LCD Display and Indicators

LCD Display
POWER
ONLINE
FAULT
SETUP
BELL
This two line by sixteen-character display is used
to convey several types of information. When the
printer is on line and printing, or ready to print,
the display will show the currently selected
tractor path and the form currently loaded in that
path. When the printer is off line, the display will
continue to show this information, additional
information based upon other buttons being
pressed by the operator, or error conditions such
as "Check Paper".
This green LED indicates that the printer is
plugged into a power source, the power switch is
on, and the internal power supply is functional.
This green LED indicates that the printer is ready
to receive printable characters and/or commands
from the host computer, and print or perform as
requested.
This red LED indicates that the printer has
detected an error condition, such as paper out,
paper jam, or an internal diagnostic error. Many
internal diagnostics are performed each time the
printer is turned on or reset, and some continue
to monitor operation during printing.
This yellow LED indicates that the setup mode
has been entered.
The printer sounds a tone when it is directed to
do so by a bell character (BEL) from the host
computer. Other tones also alert operators of
error conditions, such as paper out, and indicate
when buttons are pressed.
D A I L Y O P E R A T I O N
21