Reading The Status Indicators - Printek Mt2 Operator's Manual

The following table describes the information provided by the printer's status indicators that are located on the
top of the printer.
Indicator
Power and
Battery
Capacity
Battery
Charging
Error and
MCR Ready

Reading The Status Indicators

Indicators on Front of Printer
State Status
Printer is on and ready to receive data.
This indicator is also on if the printer is in
Green
a low power state and waiting to receive
data.
Indicates low power. Battery needs to be
Amber
recharged.
Red Very low power. Printing is not possible.
Printer is off. Printer is turned off or the
Off battery is completely discharged or
removed.
The battery charger is charging the
battery at a fast rate. If the battery is
below 5.0V, the battery is being "trickle"
Amber charged until the battery voltage reaches
5.0V, and then the fast charge rate is
started. Charging may take up to three
hours.
The battery is completely charged, or the
Off
adapter is not connected.
The MCR is ready to accept a card swipe.
Green If data is read successfully, the indicator
will turn off.
Indicates a fault condition or a printer
error. This may be due to running out of
paper, not reading the MCR data
Red
correctly, or some other error. Refer to
the Troubleshooting section on page 23
for more information.
Normal condition. Printer is ready to
Off
print.
Operation
9