Drive Components
Removing the Dust Cover
1)
Cut dust cover seal. Remove the dust cover screws with a standard flathead screwdriver.
2)
Note the setting on micrometer.
3)
Note the position of the drive gear (either above or below the packing gland pinion).
1
Removing the Adjuster
1)
Loosen the retaining screws using a standard flathead screwdriver.
2)
Slide the retaining clip up and over to the left side.
1
3)
From the top, remove the screws to adjustor plate.
4)
Lift adjustor out of the counter adapter.
5)
Remove the adjustor drive assembly.
3
Page 33
2
3
2
4
5