Ignition Cover; Measuring Dimension „Y“ - KTM 125 Repair Manual

6-11C
2
Sealing surface of the clutch
slave cylinder
push rod

Ignition cover

– Apply silicone to several points of the gasket to fix it in the ignition
– Fix the ignition cover with 4 collar bolts.
– Use the collar bolt
1
Measuring dimension „Y"
NOTE: The gasket of the driving cylinder of the clutch must be
appropriately thick to ensure smooth clutch release. For this purpose
measure dimension „Y". Dimension "Y" is the distance from the sealing
surface of the clutch slave cylinder to the push rod.
– Swing the ignition side up.
– Oil the push rod and push it into the main shaft as far as it will go.
– Then use a sliding gauge to measure the distance between the
– Write down dimension „Y" and use an appropriate gasket (see table)
A
LWAYS USE A NEW GASKET
OF THE HYDRAULIC CLUTCH
counter
shaft
cover.
2
to mount the wire bracket
carburetor air hoses on the housing.
bearing surface of the driving cylinder of the clutch and the push rod.
when mounting the driving cylinder of the clutch.
Dimension „Y"
2,5 - 2,8 mm
2,8 - 3,0 mm
3,0 - 3,3 mm
0.1 - 0.11 in
0.11 - 0.12 in
0.12 - 0.13 in
! CAUTION
. D
AMAGED GASKETS MAY IMPAIR THE EASY OPERABILITY
.
1
for the
gasket thickness
0,75 mm
0,50 mm
0,30 mm
0,30 in
0,20 in
0,012 in
!