3.0 DISASSEMBLING THE ENGINE
– Secure the engine with two screws (M8 x 45) in the engine holder.
3.1 Draining the gear oil
1
– Remove the gear oil drain plug
and the seal ring and drain the gear oil.
1
4
3.2 Ignition
2
– Remove the two retaining springs
and lift off the ignition cover.
3
3
– Take the rubber
out of the opening in the housing.
2
2
– Disconnect the spark plug connector from the spark plug.
4
5
– Remove the two screws
and washers and take off the ignition coil
.
4
5
4
6
– Insert the holding wrench
into the two bores of the flywheel and hold the
flywheel.
– Unscrew the hexagon nut of the flywheel.
6