Statuc Generator Values 125 Exe/125 Supermoto (Kokusan 2K-3) - KTM 125 Repair Manual

STATIC GENERATOR VALUES 125 EXE / 125 SUPERMOTO (KOKUSAN 2K-3)
Measuring conditions:
– cold engine
– seat and tank removed
– all connectors and the ground connection in a non-corroding condition, connectors tightly connected
– battery loaded, ignition switch to position 1 (light turned off)
– kick the kick starter forcefully at least 5 times for each measurement
8
10
Check the generator output
7
page) for voltage between the following cable colors:
– between yellow and brown (ground), connector
– between white and brown (ground), connector
– Repeat both measurements with connector
measured values should be the same.
NOTE: the black measuring lead of the peak voltage adapter must be
applied to the ground.
Check regulator rectifier output voltage
opposite page) cable colors yellow/red, regulator rectifier
bl
fuse disconnected, ignition switched off:
– between yellow/red and brown (ground)
NOTE: the black measuring lead
applied to the brown cable (ground).
S
6
(also see circuit diagram on opposite
Multimeter display: 19 volts +/- 2 volts
Multimeter display: 24 volts +/- 2 volts
9
(also see circuit diagram on
Multimeter display: 14 volts +/- 1 volt
S
of the peak voltage adapter must be
7-13C
7
disconnected
8
disconnected
7 8
and connected. The
bk
connected,