Installing The Usb-1208Hs-4Ao - Measurement Computing USB-1208HS-4AO User Manual

Installing the USB-1208HS-4AO

What comes with your USB-1208HS-4AO shipment?
As you unpack your USB-1208HS-4AO, verify that the following components are included.
Hardware

USB-1208HS-4AO

USB cable (2 meter length)
Additional documentation
In addition to this hardware user's guide, you should also receive the Quick Start Guide (available in PDF at
www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf). This booklet supplies a brief description of
the software you received with your USB-1208HS-4AO and information regarding installation of that software.
Please read this booklet completely before installing any software or hardware.
Unpacking the USB-1208HS-4AO
As with any electronic device, you should take care while handling to avoid damage from static
electricity. Before removing the USB-1208HS-4AO from its packaging, ground yourself using a wrist strap or
by simply touching the computer chassis or other grounded object to eliminate any stored static charge.
If your USB-1208HS-4AO is damaged, notify Measurement Computing Corporation immediately by phone,
fax, or email.

Phone: 508-946-5100 and follow the instructions for reaching Tech Support.

Fax: 508-946-9500 to the attention of Tech Support

Email: techsupport@mccdaq.com
For international customers, contact your local distributor. Refer to the "International Distributors" section on
our contact web page (\www.mccdaq.com/contact/).
9
Chapter 2