Instruction Manual LIGHTNING BATTERY POWERED RECHARGEABLE UPRIGHT VACUUM CLEANER (22.2V) Model: VLIGHT Please read this Instruction Manual carefully before operation and follow all guidelines before using this vacuum cleaner. Please keep this Manual for future reference.
Page 2
TABLE OF CONTENTS SAFETY INSTRUCTIONS ........................3 BREAKDOWN ............................4 UNIT ASSEMBLY............................. 5 BATTERY PACK ASSEMBLY ........................5 HOSE ASSEMBLY ........................... 6 UNIT OPERATION ........................... 6 USING THE FLOOR BRUSH ........................7 DUST CUP ASSEMBLY AND DUST RELEASE ..................7 ROLLER BRUSH ASSEMBLY ........................
SAFETY INSTRUCTIONS The device is only authorised for private, domestic use! The devices is not a toy, therefore please be particularly careful when children are around. Check the device and connections regularly for visible damage. The device must not be used if the housing is damaged or other damage is present.
BREAKDOWN A. Handle B. Dust cup handle cover C. Switch button D. Speed button E. Tube buckle F. On-board accessory storage G. Brush locking block H. Brush switch button Dust canister J. N/A K. Battery pack L. Floor brush M. Hose N.
UNIT ASSEMBLY Please ensure that the main power switch is in the off position and the battery pack is not connected before starting the assembly procedure. As per the diagram, push the handle, floor brush and dust container into the corresponding connection points on the main body.
HOSE ASSEMBLY As per the diagram, disconnect the main hose suction mouth from the rear of the floor brush. Then press the handle block and release the handle set. Hold the released main suction hose and connect to the handle connector.
USING THE FLOOR BRUSH Grip the handle, place your foot gently on the floor brush and then tilt the unit backwards to release the floor brush from the upright position. Step on the floor brush switch again to turn on the roller brush. Move the unit forward and back, left and right according to diagram to start cleaning.
ROLLER BRUSH ASSEMBLY Unscrew the roller brush pressing plate to remove the roller brush for cleaning as per the diagram. Then place roller brush back into original position and screw the pressing plate back into place. CHARGING When the battery is running low, place the battery pack into the charging base and connect the adapter to a power socket.
Thank you for purchasing your new Cleanstar product. We are confident this product will give you trouble-free use and excellent service, provided the operator uses and maintains the product in accordance with the Instruction Manual. Please read the Instruction Manual carefully before using the product for correct operation and maintenance procedures, and store it in a safe place for future reference.
Page 10
If the product was serviced or repaired by anyone other than Cleanstar, or one of Cleanstar’s Authorised Service Agents (ASA). Cleanstar is unable to accept any responsibility under this warranty for any repair work not carried out by an ASA or from the use of non-genuine parts.
Need help?
Do you have a question about the VLIGHT and is the answer not in the manual?
Questions and answers