Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CleanStar VRIP
Summary of Contents for CleanStar VRIP
-
Page 1: Instruction Manual
Instruction Manual LIL' RIPPER 10 LITRE WET & DRY VACUUM CLEANER & BLOWER Model: VRIP ● Please read this Instruction Manual carefully before operation and follow all guidelines before using this vacuum cleaner. ● Please keep this Manual for future reference. -
Page 2: Safety Directions
SAFETY DIRECTIONS IMPORTANT MESSSAGE When using an electrical appliance, basic precaution should always be followed including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire, electric shock, or injury: • Do not use outdoors. •... - Page 3 Attention!!! • Remove all contents from carton and check each item to the carton content list below.
-
Page 4: Unpacking And Setup
Unpacking and Setup • Remove the head unit by pulling the lid latched in an outward motion and remove any accessories that may have been shipped in the tank (Figure 1 & 2). • Attach the one end of the extension rods to the hose and one end to your desired accessory. Twist slightly to get a tight connection (Figure 3). -
Page 5: Dry Vacuuming Operation
Dry Vacuuming Operation - Installing the foam filter, reusable dry cloth filter and disposable vacuum bag • Install the foam filter and reusable dry cloth filter to pick up dust and dry material only. If the foam filter has been used to pick up liquids, the foam filter must be cleaned and dried before installing for dry pick up use. - Page 6 • The reusable cloth dry filter should always be in position over the foam filter for dry vacuumin unless you use a disposable vacuum bag. • To remove the filters for cleaning, remove the mounting ring and filter from cage (Figure 8 •...
-
Page 7: Emptying Liquid From The Tank
Emptying Liquid From the Tank • When you are ready to empty out the liquid in the tank please be sure to: Disconnect the power by turning off the vacuum and taking the plug from the wall. Remove the head of the vacuum by unclipping the clips on the tank. Pick up the tank and pour out the liquid contents in a suitable drain. -
Page 8: Troubleshooting
Troubleshooting Trouble Possible Cause Remedy Suction weakens or cleaner Clogged filter Brush dirt from filter. If condition runs hot continues, change filter. Air leak Check all fittings for tight fit (nozzle, hose, etc). Check the head of the vacuum is sealed properly. -
Page 9: Exploded View
Exploded View... -
Page 10: Conditions Of Warranty
Thank you for purchasing your new Cleanstar 10 Litre Wet ‘n’ Dry Vacuum Cleaner and Blower. We are confident this product will give you trouble-free use and excellent service, provided the operator uses and maintains the product in accordance with the Instruction Manual. - Page 11 If the product was serviced or repaired by anyone other than Cleanstar, or one of Cleanstar’s Authorised Service Agents (ASA). Cleanstar is unable to accept any responsibility under this warranty for any repair work not carried out by an ASA or from the use of non-genuine parts.
Need help?
Do you have a question about the VRIP and is the answer not in the manual?
Questions and answers